Heya- I’ve run afoul of some issues trying to follow Grant’s guidance in the matter of making a cavity map for my ork. Not sure if my retopo was lousy, my seams off, if my shrinkwrap somehow caused some hiccups, or if my baking options are off. I seem to get a lot of holes in my islands, and I can’t seem to fix this issue despite fiddling around with baking options. Can provide further files if it’ll help?
1 Like
Lots of answers already in the ask section, to this black bits in bakes.
Just use extrusion, next to the Ray distance.
Set extrusion to 0.002 As a first test, these numbers will vary by model and HP/LP fit.
Set Max Ray Distance, you can probably leave it at zero. But again it is a number that may need adjusting to your use case.
Play with these numbers until you get a good result. This bit is not a matter of using X and Y numbers as every model varies. It often needs several tries to find a good pair of values.
3 Likes
See also:
1 Like
This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.