What i did, is:
Make 2 extra loopcuts, aligned with the exsisting two.
select each step corner, press gg and pull em down
Thats how i created this. Is it a correct way?
I presume you mean to create your ramp?
There are plenty of different ways to achieve results in Blender, so there is usually no “correct way”. So sure, this sounds like a valid way. If you haven’t already, remember to remove doubles - there’s a reminder of how to do this at the end of the lesson.
The top-most section of the ramp looks a bit off, as if it’s been set to a different angle?
This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.