Hi, I had a think after doing the subdivision chapter and wondered if I could reproduce the stairs directly from the edges left after my ramp is deleted.
I selected the side edges of the gap left by the ramp being deleted. Then I subdivided them both by 62 because I wanted 31 steps. I then selected every other edge and grabbed them in the x direction until they made a front facing edge of a step. This worked fine but I had to fiddle a bit to get the top step from face correct and that has left my top step lightly wider than the others. Is there a way to resize ALL the steps so that they still connect top and bottom but are equal sizes? Thanks.
Here is my image
