Pyramid railings

Hi all!

I have to admit, I’m finding myself needing to rely on Mike’s model answer to challenges more than I have in the past. Definitely in need of some practice (ideas for practice models welcomed!), but that’s the fun part of learning. :slight_smile:

My doorway/slanted entrance was actually too wide for my railing, which created a problem when completing the railing. I could vertex snap the bottom of my railing to the bottom of the entrance, but then couldn’t find a way to snap the top and just did this by sight. The end result was correct but just didn’t look right so I went back and narrowed my entrance a bit, then snapped the railing to it. Much happier with that. :slight_smile:

3 Likes

Maybe join the weekly Blender collaboration.

2 Likes

Well done. You found ways to get it done. Perhaps repeat it, knowing the problems you had ahead of doing it.

There is also the good old ‘undo’, go backwards and not make the entrance an awkward size for later!

1 Like

I didn’t know about that, thanks FedPete!

1 Like

Privacy & Terms