Pillar has a weird cliff when extruding

So I am at 6:56 in the pillar tutorial and I seem to have this weird cliff on my pillar. I don’t see what I’m doing wrong


Looks like you have extra geometry. I suspect a previous go at extruding was canceled before this one. However escape to cancel extrude, leaves behind extra geometry.

Fixing it. You could go back, remake it.

Or in vert mode select the 4 verts holding the ledge out and delete them.

Then, as I suspect there is also extra vert in the lower section, Press A to select all and then M, by distance, to merge away double geometry.


That worked thank you

1 Like

This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.

Privacy & Terms