Lesson 186 - Head building challenge

eisens · May 21, 2020, 1:51pm

Hi all, This is the beginning of my head project,
It’s quite difficult not able to see both the image reference and the mesh at the same time…
I managed at last but the mesh hides the ref pic.
If I work on wire frames then it’s very hard to see clearly the morphology of the mesh…
So that was the main difficulty for me.

Other then that- My cursor somehow doesn’t show me the direction of pulling/pushing
it doesn’t ‘sit’ on the 3d face… did anyone encounter that?

Thanks
Shira

NP5 · May 21, 2020, 5:54pm

You can move the reference in front of the model and make that image semi transparent. That may help.

Good going so far.

simgen · January 6, 2021, 5:40pm

I encountered that too… Downloading the newest Blender version solved that (been using same version since June).

eisens · January 6, 2021, 8:08pm

Thanks.
That was a relatively old post of mine… since then I managed… I think the problem was I wasn’t on Edit mode … That’s if I remember right was the reason of the cursor not showing…