Hey so im following what hes doing and no matter what I do, I cant seem to get rid of the pinch in the middle, I don’t know if its because they’re too close or if I beveled too much and I don’t really know how to fix it
1 Like
Its difficult to say without actually seeing geometry. Snap shot with mesh would be helpful.
2 Likes
Ive tried to recreate the problem. Ive made the same geometry and it isnt the issue for me. No idea
Go figure.
Have you tried looking for doubles?
1 Like
i think i got it fixed. just remade it and made the finger holes spheres from the start and not the hexagons
1 Like
Well done. Main thing is perserverance.
1 Like
You don’t have quad faces in the middle.
A quad face has only four vertices.
use knife tools. Or select the two vertices UP and DOWN, press j.
1 Like
If you look closely at your wireframe first post, you will see an internal face joining the two holes, it needed deleting.
FedPete’s topology correction is also important.
Well done just redoing it and solving some of it!
2 Likes