Bowling pin. Well I locked it in with a lot more faces than the lecture

Trever_Grissam · December 7, 2018, 10:49pm

hope this does not cause an issue lol

Dudge_Dude · December 10, 2018, 6:26pm

Only 1 way to find out right? Do you have the answer yet?

Trever_Grissam · December 13, 2018, 9:03pm

I had to decimate collision mesh one extra time than video to get bottom with an edge loop. This may have made the mid diameter shrink a tiny amount I am not sure yet. I had a lot of work just got back to lessons I think it should be fine though. Just slightly cleaner edge at top of my pin lol.