2 Likes
Use the extrusion factor in the bake panel next to the ray distance it is new since the lectures were made and makes all the difference.
Set extrusion to 0.001 As a first test, these numbers will vary by model and HP/LP fit.
Set Max Ray Distance, you can probably leave it at zero. But again it is a number that may need adjusting to your use case.
Play with these numbers until you get a good result. This bit is not a matter of using X and Y numbers as every model varies. It often needs several tries to find a good pair of values.
4 Likes
thank you so much. i was so confused !
3 Likes
This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.