I’m not sure what I do wrongly but at 3:40 of the cyborg video grant says we should select the faces around the arm and extrude inwards. But when I press extrude it moves in wonky directions and not into the center of the object at all. When I scale instead it seems to work, but then the following vertical loop cuts don’t work around the object but only parts of it.
Just wondering if anyone else had problems with that part.
OK, I found the problem.
Grant correctly says extrude and then scale - but the commands only showed E for extrude and no S for scale so I assumed the scale was just a figure of speech but it turns out that the correct sequence of keys is indeed E and then S. So problem solved.
Welcome to this site and very well done solving your own question! 
This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.