I have holes at the top ant at the bottom of my pin. Where could I have gone wrong? I put the start and end of bezier curve exactly at 1.9 and -1.9 as instructed. The only diffrence I was working from the top view instead of the front view.
Maybe you should set your curve’s top and bottom vertices’ x and y to 0.So that the two vertices could stick to z axis while spinning.
Not sure if it is the problem.
3 Likes
Yes, I think that is the problem as well. Try panning around your cure before you spin it, it likely is three-dimensional instead of two-dimensional.
1 Like
I played around with those ending points and finally was able to make my pin not holy anymore. (Don’t really know how, but i made it, oh god, I hope that counts)
Thanks for the advice it helped 
2 Likes